![]() ASME B31.3 Process Piping Fluid Velocity And Flow Rate Calculation Module.ASME B31.3 Process Piping Elastic Modulus Calculation Module.ASME B31.3 Process Piping Design Pressure Calculation Module.ASME B31.3 Process Piping Design Factor Calculation Module.ASME B31.3 Process Piping Branch Reinforcement Calculation Module.ASME B31.3 Process Piping Blank Flange Calculation Module.ASME B31.3 Process Piping Basic Allowable Stress Calculation Module.ASME B31.3 Process Piping Allowable Bolt Load And Bolt Stress Calculation Module.Reference : ANSI/ASME B31.3 : Process Piping (2018) Change Module : Use the workbook ASME B31.3 data tables to look up allowable stress data. Use the goal seek option to calculate the required miter bend nominal wall thickness for the design pressure. The allowable pressure for miter bends is calculated from the nominal wall thickness. ![]() Use the goal seek option to calculate the required straight pipe nominal wall thickness (before bending), for the minimum thickness on the outside radius (after bending). The estimated minimum bend thickness after thinning should be ≥ the required minimum bend thickness on the outside radius (extrados). Bend thinning on the outside radius is estimated using the method from ASME B31.1. Minimum thickness of formed bends is calculated for the inside radius, the oputside radius, and the centerline radius. Calculate ASME B31.3 process piping minimum thickness for formed bends, and allowable pressure for miter bends.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |